Cyprus Journal of Medical Sciences
Original Article

In Vitro Comparative Evaluation of Er,Cr:YSSG Laser and Conventional Etching Methods on the Microleakage and Adaptation of Pit and Fissure Sealants

1.

Department of Pediatric Dentistry,, Near East University, Nicosia, Cyprus

2.

Darıca Oral and Dental Health Center, Kocaeli, Turkey

3.

Department of Pediatric Dentistry,, Near East University, Nicosia, Cyprus; Pediatric Dentistry Department, Kyrenia University, Kyrenia, Cyprus

Cyprus J Med Sci 2018; 3: 85-89
DOI: 10.5152/cjms.2018.569
Read: 1387 Downloads: 402 Published: 23 July 2019

Abstract

BACKGROUND/AIMS: The main objectives of the current research were to compare the conventional etching and alternative laser etching techniques and to evaluate the microleakage and Scanning Electron Microscope (SEM) analysis of pit and fissure sealants.

 

METHODS and MATERIALS: The extracted teeth were randomly selected, and 120 extracted teeth were divided into four experimental groups as follows: Group 1: Bur invasion and Conventional acid etching; Group 2: Bur invasion and Laser etching; Group 3: Laser etching; and Group 4: Laser etching and Conventional acid etching. According to experimental groups, teeth were treated with 37% phosphoric acid and laser parameters were set at a 2780 nm wavelength with a 140-µs pulse duration and a pulse repetition rate of 20 Hz. The power output was determined to be 1.75 watts. Then, a thermal cycle was applied to all samples to imitate an oral environment. After the thermal cycle procedure, each experimental group was randomly divided into two groups for microleakage tests and SEM analysis.

 

RESULTS: No statistically significant difference in microleakage scores was determined among the experimental groups (p>0.05). The fissure sealant adaptation was detected to be higher in Group 1 than in Group 2 and Group 3, and this difference was found to be statistically significant (p<0.05). The same trend was observed in Group 4, Group 3, and Group 2, with Group 4 having the higher fissure sealant adaptation (p<0.05).

 

CONCLUSION: Er,Cr:YSSG laser and acid etching combination can be a good choice and is comparable to bur invasion from the standpoint of the high pit and fissure adaptation.


Cite this article as: İslam A, Kızılelma Z, Çetiner S. In Vitro Comparative Evaluation of Er,Cr:YSSG Laser and Conventional Etching Methods on the Microleakage and Adaptation of Pit and Fissure Sealants. Cyprus J Med Sci 2018; 3: 85-9.

Files
ISSN 2149-7893 EISSN 2536-507X